-
Start by blitzing the biscuits in a food processor to a fine crumb, then with the motor still running, pour in the melted butter, pulsing to mix.
-
Tip into a 7 inch diameter spring form cake tin (I like to line mine with my reusable silicone liners) and press into the base and up the sides to give as even a layer as you can.
-
Clean out the food processor and then blitz all the filling ingredients together - pour into the tin on top of the base slowly and gently. It should find it's own level.
-
Now pour 250ml of water into the Instant Pot and place the trivet on top with the arms folded down.
-
Take a long piece of foil and fold lengthways to make a strip long enough to allow you to lower the cheesecake on to the trivet and retrieve when cooked. Do this now. Then take 4 or 5 pieces of kitchen roll and tuck them over the cheesecake, trying to tent them around the tin before folding the foil very gently over enough to allow you to put the lid on.
-
When closed, ensure the vent is set to "Sealing" and select Manual, adjusting time to 25 minutes.
-
Leave for 10 minutes after cooking time finished to give you a Natural Pressure Release then remove the lid, discard the now wet kitchen roll and using the foil sling, carefully remove the cheesecake. It should have a hint of a wibble wobble in the middle still.
-
Cool on a rack and when at room temp, chill for a minimum of 4 hours if not over night in the fridge.
-
When ready to serve, unmould the tin and transfer to a serving plate (cheesecakes in the IP are smaller and the bases more sturdy so this is easier than by traditional baking methods).
-
Whip the double cream and pipe 8 blobs out around the top of the cheesecake and top each other these with a second smaller blob. Top with a Snow Bite to make them look like little snowmen and scatter over the zest of the second lime. Serve with a jug of Snowball cocktails on the side!